.
SUBSCRIBE TO SMS UPDATES
Error Message: Disk Boot failure
Posted by avnrurfriend in ZEAL on Wednesday, April 28, 2010
If your computer has just been formatted, your computer might require you to insert the boot CD to be able to run it. You might hence get the error message “Disk Boot Failure- Insert disk and press enter” displayed on the screen every time you will try to run it. This might be linked to:
1. The boot options not correctly set in BIOS
2. A non bootable CD is found in your CD drive
3. You do not possess any bootable device
4. You have installed a new hard disk
5. The hard disk is not properly plugged
6. Your system files have been infected
Solution 1: Ensure that your drives are empty
If there is a non bootable CD or disk in the drives, your computer might be attempting to boot the program with this disk. Hence, ensure that the floppy disk drive, the CD/R and DVD drives are all empty before restarting your computer and trying to run computer again.Solution 2: BIOS set up
If this has not solved the problem, it might be linked to a wrong set up of BIOS. Hence,1. To enter BIOS, press the F8 key when the Windows screen shows up upon the start of the computer.
2. Then all you have top do is to prioritize the boot sequence to Disk C:
Solution 3: New hard drive configuration
If you have just installed a new hard drive, you should insert the system installation CD and restart your computer again so that it reboots with the CD.Solution 4: Hard drive not properly plugged in
If your hard drive is not properly plugged in, this can also lead to a rebooting error message. Hence, I will suggest you to switch off your computer and remove it from the power switch before checking the cables attached to it. Ensure also that the motherboard is correctly installed. Hence, put it again and try running your system.Solution 5: Restore the corrupted system files
If neither solution has solved your issue, then it might be due to a corruption of your system files. Hence,1. Start your computer with a system boot CD and once it is running, enter the command “Dir C:” to ensure that you can access the C: drive’s contents.
2. If the computer enables you to access the contents, then you can enter the command
“fdisk /mbr
sys c:”
This entry was posted on Wednesday, April 28, 2010 at 8:22 PM and is filed under ZEAL. You can follow any responses to this entry through the RSS 2.0. You can leave a response.
- No comments yet.
